Information AboutTill |
| CATEGORIES ABOUT TILL | |
| glaciology | |
| sedimentary rocks | |
| sediments | |
|
Till is an unsorted Glacial sediment. Glacial drift is a general term for the coarsely graded and extremely heterogeneous Sediment s of glacial origin. Glacial till is that part of glacial drift which was deposited directly by the glacier. It may vary from Clay s to mixtures of clay, Sand , Gravel and Boulder s. A particularly sticky form of clay till is called gumbo. Clay in till may form in Spherical shapes called ''till balls''. If a till ball rolls around in a stream, it may pick up rocks from the streambed and become covered by rocks; thence it is known as an armored till ball. Till is deposited at the Terminal Moraine , along the Lateral and Medial Moraines and in the Ground Moraine of a glacier. As a glacier melts, especially a Continental Glacier , large amounts of till are washed away and deposited as outwash in Sandur s by the River s flowing from the glacier and as Varve s in any Proglacial Lake s which may form. Till may contain Alluvial Deposit s of Gem s or other valuable Ore minerals picked up by the glacier during its advance, for example the Diamond s found in Wisconsin , Indiana , and Canada . Prospector s use trace minerals in tills as clues to ''follow'' the glacier ''upstream'' to find Kimberlite diamond deposits and other types of ore deposits. TILLITE In cases where till has been indurated or Lithified by subsequent burial into solid rock, it is known as the Sedimentary Rock ''tillite''. Matching beds of ancient tillites on opposite sides of the south Atlantic Ocean provided early evidence for Continental Drift . The same tillites also provided the key evidence for the Precambrian Snowball Earth glaciation event. TYPES OF TILL There are various types of classifying tills:
Traditionally (e.g. Dreimanis , 1988), a further set of divisions has been made to primary deposits, based upon the method of deposition.
Some (e.g. Van der Meer et al. 2003) have suggested that these till classifications are outdated and should instead be replaced with only one classification, that of deformation till. The reasons behind this are largely down to the difficulties in accurately classifying different tills, which are often classified based on inferences of the physical setting of the till rather than till fabric or particle size analysis data. SEE ALSO |
|
|