| Chopped And Channeled |
Article Index for Chopped |
Shopping Chopped |
Website Links For Channeled |
Information AboutChopped And Channeled |
| CATEGORIES ABOUT CHOPPED AND CHANNELED | |
| vehicle modification | |
|
CHOPPING show car that was built using a 1968 AMC Javelin production car]] To chop a roof the Pillar s and Window s are cut down, lowering the overall roofline. "Chopping the top" goes back to the early days of hot rodding in an attempt to reduce the frontal profile of a car and increase its speed potential. Some racers on the dry lakes chopped the tops of their cars so severely that the windows were only a few inches tall. These were sometimes referred to as "mail slot" windows. This sort of bodywork is also popular on Custom Car s, Kustom s, and Leadsled s. Roof chopping also quickly became very popular with Drag Racer s for much the same reasons as it did for lakes racers. The first roof chopper is considered to be Sam Barris (see article about His Brother ) who chopped and customised his brand new 1949 Mercury . Barris also pioneered a more advanced form, where the B-pillar is removed turning it into a Pillarless Hardtop in the process. Concept Cars often undergo a lowering of their roofs even if the vehicles are based on production models. Automaker s use the chopping technique to make them look more "racy", although it would be impractical for normal use. ]] CHANNELING To Channel a car the body is also lowered over the frame by removing the floor & refastening it higher inside the body, causing the body to rest closer to the ground without altering the suspension. The overall effect is to give the car body a more massive appearance. Each automobile would have its own engineering challenges as far as modifying the various components of the chassis. Local laws may prevent making the modifications too extreme, and safety would dictate some restraint. Channeling is also popular amongst Hot Rod , Leadsled and Minitruck enthusiasts, though the latter refer to it as a "body drop". SECTIONING A related process to channeling a car (and one that has almost the same aim) is Sectioning. Sectioning is the act of removing a horizontal section from the body of a Car , lowering the top half onto the bottom half and Welding the result back together. The purpose is to reduce the overall height of the bodywork of the car. Likle a roof chop, it also has the advantage of reducing a car's frontal area and reducing Wind Resistance . This sort of bodywork is popular on Minitruck s, Custom Car s, Kustom s, and Leadsled s. EXTERNAL LINKS |
|
|