World3 Nonrenewable Resource Sector Website Links For
Resource 		 

Information About

World3 Nonrenewable Resource Sector
  CATEGORIES ABOUT WORLD3 NONRENEWABLE RESOURCE SECTOR
   
economics models
   
environmental economics
   
systems theory
   
simulation software
   
APPAREL
BABY
BEAUTY
BOOKS
CAR TOYS
CELL PHONES
DVD'S
ELECTRONICS
GOURMET FOOD
GROCERIES
HEALTH & PERSONAL
HOME & GARDEN
JEWELRY
MUSIC
MUSIC INSTRUMENTS
OFFICE PRODUCTS
SOFTWARE
SPORTING GOODS
TOOLS & HARDWARE
TOYS
VIDEO GAMES
SHOPPING HOME
MORE SHOPPING...



The world3 nonrenewable resource sector is the portion of the World3 model that simulates the nonrenewable resources. This model assumes that regardless of how much money is spent on extraction, there is a finite limit for the amount of nonrenewable resources that can be extracted.

The model combines all possible nonrenewable resources into one aggregate variable, nonrenewable_resources. This combines both energy resources and non-energy resources. Examples of nonrenewable energy resources would include oil and coal. Examples of material nonrenewable resources would include aluminum and zinc. This assumption allows costless substitution between any nonrenewable resource. The model ignores differences between discovered resources and undiscovered resources.

The model assumes that as greater percentages of total nonrenewable resources are used, the amount of effort used to extract the nonrenewable resources will increase.
  • other_factors---(1-fcaor). This causes the amount of resources expended to depend on the amount of industrial capital, and not on the amount of resources consumed.


The fraction of capital allocated to obtaining resources is dependent only on the nonrenewable_resource_fraction_remaining, or abbreviated nrfr. This variable is the current amount of non-renewable resources divided by the initial amount of non-renewable resources available. As such nrfr starts out as 1.0 and decreases as world3 runs. Fraction of capital allocated to obtaining resources is dependent on nrfr as interpolated values from the following table:

  • other_factors---(1-fcaor) So, if industrial capital and the other factors (described in the capital sector) are the same, then 1 unit of the effective capital when nrfr is 1.0 the effective output is 0.95 (= 1.0 --- ( 1 - 0.05)). So, when nrfr is 0.5, the effective output is 0.90 (= 1.0 --- (1 - 0.10)). Another useful way to look at this equation is to reverse it and see how much effective capital is required to get 1 unit of effective output (i.e. effective_output / (1 - fcaor) = effective_capital). So, when nrfr is 1.0, the effective capital required for 1 unit of effective output is 1.053 (=1.0/(1-0.05)), and when nrfr is 0.3, the effective capital required is 2 (=1.0/(1-0.5)). Lastly is looking at the relative cost required for obtaining the resources. This based on the fact that it requires 1/19 of a unit of effective capital extra when the nrfr is 1.0. So, (effective capital required - 1.0) / (1 / 19) will give the relative cost of obtaining the resources compared to the cost of obtaining them when nrfr was 1.0. For example, when nrfr is 0.3, the effective capital required is 2.0, and 1.0 of that is for obtaining resources. So, the cost of obtaining the resources is (2.0 - 1.0) / ( 1 / 19) or 1.0---19 or 19 times the cost when nrfr was 1.0. Here is a table showing these calculations for all the values:




REFERENCES


  • Models of Doom, A Critique of the Limits to Growth, edited by H.S.D. Cole, Christoper Freeman, Marie Jahoda, and K.L.R. Pavitt. 1973 ISBN 0-87663-905-8 (Especially Chapter 3: The Non-renewable Resource Sub-System)

  • Dynamics of Growth in a Finite World, by Dennis L. Meadows, William W. Behrens III, Donella H. Meadows, Roger F. Naill, Jørgen Randers, and Erich K.O. Zahn. 1974 ISBN 0-9600294-4-3 (Especially Chapter 5: Nonrenewable Resource Sector)