in math prevents it from being rendered as HTML, which
can't handle nested exponents -->
(also '''exponential map''', '''hyperpower''', '''power tower''', '''super-exponentiation''', and '''hyper4''') is '''iterated exponentiation''', the first Hyper Operator after exponentiation. The Portmanteau Word ''tetration'' was coined by Reuben Louis Goodstein from Tetra- (four) and Iteration . Tetration is used for the Notation Of Very Large Numbers .
Tetration follows Exponentiation in the sequence:
# Addition
#:
# Multiplication
#:
# Exponentiation
#:
#tetration
#:
where each operation is defined by iterating the previous one.
Multiplication () can be thought of as ''B instances of A added together'', and consequently exponentiation () can be thought of as ''B instances of A multiplied together''. So a step further can be taken, and tetration () can be thought of as ''B instances of A exponentiated together''.
Note that when evaluating multiple-level exponentiation, the exponentiation is done at the deepest level first (in the notation, at the highest level). In other words:
:
: is not equal to
To generalize the first case (tetration) above, a new notation is needed (see below); however, the second case can be written as
:
Thus, ''its'' general form still uses ordinary exponentiation notation.
The notations in which tetration can be written (some of which allow even higher levels of iteration) include:
- Standard notation: — first used by Maurer ; Rudy Rucker 's book popularized the notation.
- Knuth's Up-arrow Notation : — allows extension by putting more arrows, or equivalently, an indexed arrow
- Conway Chained Arrow Notation : — allows extension by increasing the number 2 (equivalent with the extensions above), but also, even more powerfully, by extending the chain
- hyper4 notation: — allows extension by increasing the number 4; this gives the family of Hyper Operator s
For the Ackermann Function we have , i.e.
The up-arrow is used identically to the caret (^), so that the tetration operator may be written as ^^ in ASCII : a^^b.
-
-
-
-
- (over 2,000 Digit s long)
- (over 36,000 digits long)
- (over 400,000 digits long)
-
-
- (over three Trillion digits long)
-
- (nearly 20,000 digits long)
Using the relation (which follows from the definition of tetration), one can derive (or define) values for where .
This confirms the intuitive definition of as simply being . However, no further values can be derived by further iteration in this fashion, as is undefined.
Similarly, since is also undefined (), the derivation above does not hold when = 1. Therefore, must remain an undefined quantity as well. (The figure can safely be defined as 1, however.)
Sometimes, is taken to be an undefined quantity. In this case, values for cannot be defined directly. However, is well defined, and exists:
:
This limit holds for negative , as well. could be defined in terms of this limit and this would agree with a definition of .
Since Complex Number s can be raised to powers, tetration can be applied to numbers of the form , where is the Square Root of −1. For example, where , tetration is achieved by using the Principal Branch of the natural logarithm, and noting the relation:
:
This suggests a recursive definition for given any :
:
:
The following approximate values can be derived, where is ordinary exponentiation (i.e. ).
Solving the relation yields the expected and , with negative values of giving infinite results on the imaginary axis. Plotted in the Complex Plane , the entire sequence spirals to the limit , which could be interpreted as the value where is infinite.
Such tetration sequences have been studied since the time of Euler but are poorly understood due to their chaotic behavior. Most published research historically has focused on the convergence of the power tower function. Current research has greatly benefited by the advent of powerful computers with fractal and symbolic mathematics software. Much of what is known about tetration comes from general knowledge of complex dynamics and specific research of the exponential map.
Extending to real numbers is straightforward and gives, for each natural number , a . (The term ''super'' is sometimes replaced by ''hyper'': '''hyper-power function''').
As mentioned above, for positive integers the function tends to 1 for tending to 0 if is even, and to 0 if is odd, while for and the function is constant, with values 1 and 0, respectively.
At this time there is no commonly accepted solution to the general problem of extending tetration to the real or complex numbers, although it is an active area of research.
Consider the problem of finding a or '''hyper-exponential function''' which is an extension to real to what was defined above, satisfying (for ):
- it is monotonically increasing
- it is continuous
When is defined for an interval of length one, the whole function easily follows for all
A simple solution is given by for |