Specific Heat Article Index for
Specific 		Website Links For
Specific 		 

Information About

Specific Heat
  CATEGORIES ABOUT SPECIFIC HEAT CAPACITY
   
chemical properties
   
physical quantity
   
thermodynamics
   
heat
   
fundamental physics concepts
   
APPAREL
BABY
BEAUTY
BOOKS
CAR TOYS
CELL PHONES
DVD'S
ELECTRONICS
GOURMET FOOD
GROCERIES
HEALTH & PERSONAL
HOME & GARDEN
JEWELRY
MUSIC
MUSIC INSTRUMENTS
OFFICE PRODUCTS
SOFTWARE
SPORTING GOODS
TOOLS & HARDWARE
TOYS
VIDEO GAMES
SHOPPING HOME
MORE SHOPPING...



The specific heat capacity (the symbol ''c'' or ''s'', also called '''specific heat''' or SHC) of a substance is defined as Heat Capacity per unit Mass . The SI unit for specific Heat capacity is the ''''' Joule per Kilogram Kelvin ''''', J·kg-1·K-1, which is the amount of energy required to raise the Temperature of one Kilogram of the substance by one Kelvin . Heat capacity can be measured by using Calorimetry .

The equivalent definition using Cgs units is the amount of energy (measured in Erg s) required to raise the Temperature of one Gram of the substance by one Degree Celsius (erg/(g·°C)).
Other units of specific heat capacity include Calorie s per gram degree Celsius (cal/(g·°C) or cal/(g·K)) and Btu per pound degree Fahrenheit (Btu/(lb·°F)).

The symbols ''cp'' and ''cv'' are often used to denote specific heat capacity at constant pressure and at constant volume.

Substances with low specific heat such as metals require less input energy to increase their temperature. Substances with high specific heat such as water require much more energy to increase their temperature. The specific heat can also be interpreted as a measure of how well a substance preserves its temperature, i.e. "stores" heat, hence the term "heat capacity".


FACTORS THAT INFLUENCE HEAT CAPACITY MEASUREMENTS

  • Temperature: Measuring the heat capacity of Water produces different results if the starting point is 20 °C rather than 60 °C. Therefore the temperature at which the measurement was conducted must be specified for the value to be useful.

  • '''ing in liquid water) are likely to increase the heat capacity of a substance. In solid substances, heavy atoms tend to increase heat capacity by making Quantum Vibration modes more accessible by decreasing their spacing. In the case of an Ideal Gas , intermolecular forces are absent from the system, thus the specific heat capacity is independent of Pressure which forces molecules closer together and to interact more often. Helium behaves much like an Ideal Gas at Standard Ambient Temperature And Pressure

  • For a Gas , it is necessary to distinguish between specific heat at constant pressure (usually noted c_p) and at constant volume (usually noted c_v). The former, which is also the most commonly used, applies to a gas evolving at constant pressure (such as a gas being heated in a loose bag which allows free expansion), and the latter applies to a gas evolving at constant volume, such as a gas heated in a sealed container which does not change size. Contant pressure heat capacities are always larger for a gas, because heat is absorbed to do the work which is done when the gas expands against external pressure, if it is allowed to do so. ---Two analogous distinct capacities can also be defined for liquids and solids. The difference between the two is generally not worth considering at normally encountered conditions since liquids and solids are nearly incompressible at these pressures, so that their thermodynamic behavior is not significantly affected. On the other hand, at very high pressures (such as deep in the Earth) pressures can be high enough to not only change volumes of solids and liquids significantly, but also do a great deal of work with a relatively small change in volume. Here the difference between the two kinds of heat capacities again becomes important.



TABLE OF SPECIFIC HEAT CAPACITIES



SPECIFIC HEAT OF BUILDING MATERIALS

Usually of interest to builders and solar designers


SEE ALSO