| Hot Cathode |
Article Index for Hot |
Website Links For Hot |
Information AboutHot Cathode |
| CATEGORIES ABOUT HOT CATHODE | |
| vacuum tubes | |
|
:''Hot cathode is also a name for a Hot Filament Ionization Gauge , a vacuum measuring device. In Vacuum Tube s, a hot cathode is a Cathode electrode which emits Electron s due to Thermionic Emission . (''Cf.'' Cold Cathode s, where Field Emission is used and which do not require heating.) The heating element is usually an Electrical Filament . Hot cathodes typically achieve much higher power density than cold cathodes, emitting significantly more electrons from the same surface. Hot cathodes may be either directly heated, where the filament is itself the source of electrons, or indirectly heated, where the filament is electrically insulated from the cathode itself. The filament is most often made of Tungsten . In the indirectly heated cathodes, the filament is usually called heater instead; this configuration minimizes the introduction of hum when the filament was energized with Alternating Current . The cathode for indirectly heating is usually realized as a nickel tube coated with the emissive layer. The cathode is typically covered with an emissive layer, made of a material with lower Work Function , which emits electrons more easily than bare tungsten metal, reducing the necessary temperature and lowering the emission of metal ions. A common approach is a oxide-coated cathode. The earliest material used was is used as well. Oxide-coated cathodes operate at about 800-1000 °C, orange-hot. They are used in most of small glass tubes. They are rarely used in high-power tubes, as they are sensitive to high voltage and oxygen ions and undergo rapid degradation under such conditions. {Link without Title} For the manufacturing convenience, the oxide-coated cathodes are usually coated with Carbonate s, which are then converted to oxides by heating, and the metal monolayer has to be formed, in a process called electrode activation. The activation may be achieved by microwave heating, direct electric current heating, or electron bombardment while the tube is on the exhausting machine, until the production of gases ceases. The purity of cathode materials is crucial for the tube lifetime. {Link without Title} Thoriated filaments are another option. A small amount of Thorium is added to the tungsten of the filament. The filament is heated white-hot, at about 2400 °C, thorium atoms migrate to the surface of the filament, and form the emissive layer. Thoriated filaments can last for very long time and are resistant to high voltages. They are used in nearly all big high-power vacuum tubes for radio transmitters, and in some tubes for hi-fi amplifiers. Their lifetimes tend to be longer than of oxide cathodes. {Link without Title} The emissive layers degrade slowly with time, and much quicker when the cathode is overloaded with too high current. The result is weakened emission and diminished power of the tubes, or brightness of the CRTs, affected. The activated electrodes can be destroyed by contact with Oxygen or other chemicals (eg. Aluminium , or Silicate s), either present as residual gases, entering the tube via leaks, or released by Outgassing or migration from the construction elements. This results in diminished emissivity. This process is known as cathode poisoning. High-reliability tubes for the early computer Whirlwind had to be developed, with filaments free of traces of Silicon . Slow degradation of the emission layer and sudden burning and interruption of the filament are two main failure modes of vacuum tubes. Hot cathodes are the main source of electrons in Electron Gun s in Cathode Ray Tube s, Electron Microscope s, Vacuum Tube s, and in some Fluorescent Lamp s. |
|
|