| Flame Test |
Article Index for Flame |
Website Links For Flame |
Information AboutFlame Test |
| CATEGORIES ABOUT FLAME TEST | |
| chemical tests | |
|
The flame test is a procedure used in Chemistry to detect the presence of certain Metals . It involves introducing a sample to a flame, and observing the color that results. The test is based on the fact that each Element has its own characteristic Emission Spectrum . Samples are often held on the looped end of a clean, nonreactive wire (it's best with Platinum or Gold , although Nichrome is used as a substitute) or on the tip of a wood stirring stick soaked in water. Sodium is a common component or Contaminant in many compounds and its spectrum tends to dominate over others. The test flame is often viewed through Cobalt Blue Glass to filter out the yellow of Sodium and allow for easier viewing of other Metals . The main advantage of the flame test is that it is fast and easy to conduct, and does not require any special equipment. However, the range of detected elements is small, and the test relies on the Subjective experience of the experimentalist than any objective measurements. The test has difficulty detecting small concentrations of some elements, while too strong a result may be produced for certain others, which tends to drown out weaker signals. Finally, the test only gives Qualitative information, not Quantitative data about the actual proportion of elements in the sample. RELATED METHODS The flame test is also the predecessor of the FAAS , Flame Atomic Absorption Spectrometer . There is also a similar, though more complicated but precise test - the Borax Bead Test . COMMON METALS Some common metals and corresponding colors are: HOW TO PERFORM A FLAME TEST # Use a wire loop, usually made of Platinum or Nichrome . # If the wire loop has been previously used for a flame test, it must be cleaned. Dip it into concentrated Hydrochloric Acid and then hold it in a non-luminous flame until no discolouration of the flame can be observed. # Rinse the wire loop in Distilled or Deionized Water . # Dip the clean loop into an ionic Salt or Solution and pass it into the non-luminous flame. # Blue Cobalt Glass may be desirable to filter Sodium's light if sodium ions are present in the solution. EXTERNAL LINKS
|
|
|