Information AboutPrecession |
|
Torque-free precession Only moving objects can be in torque-free precession. For example, when a plate is thrown, the plate may have some rotation around an axis that is not its axis of symmetry. When the object is not perfectly solid, internal Vortices will tend to damp torque-free precession. Torque-induced precession Torque-induced precession (gyroscopic precession) is the phenomenon by which the Axis of a spinning object (e.g. a part of a Gyroscope ) "wobbles" when a Torque is applied to it. The phenomenon is commonly seen in a spinning Toy Top , but all rotating objects can undergo precession. If the speed of the rotation and the magnitude of the torque are constant the axis will describe a cone, its movement at any instant being at right angles to the direction of the torque. In the case of a toy top, if the axis is not perfectly vertical the torque is applied by the Force of Gravity trying to tip it over. A rolling wheel will tend to remain upright due to precession. When the wheel tilts to one side, the particles at the top are pushed to one side and the particles at the bottom are pushed the other way. However, since the wheel is rotating, these particles eventually switch places and cancel one another out. Precession or gyroscopic considerations have an effect on Bicycle performance at high speed. Precession is also the mechanism behind Gyrocompass es. This concept is easier to understand by examining the effects of Inertia , which is often stated by the phrase "A body in motion tends to stay in motion." In this case the "motion" of a rotating body is in its rotation. If an external force pushes upon the rotating body, the body will resist the force by pushing back against it, but the reaction is delayed. Gyroscopic precession also plays a large role in the flight controls on helicopters. Since the driving force behind helicopters is the rotor head (which rotates), gyroscopic precession comes into play. If the rotor head is tilted to the right, its counter-clockwise movement forces the aircraft to fly forward. To ensure the pilot's inputs are correct the aircraft has corrective linkages which tilt the rotor head to the right when the pilots push the "cyclic stick" forward, or to the left when the stick is pulled to the back. The physics of precession Precession is the resultant of the Angular Velocity of rotation and the angular velocity produced by the torque. It is an angular velocity about a line which makes an angle with the permanent rotation axis, and this angle lies in a plane at right angles to the plane of the couple producing the torque. The permanent axis must turn towards this line, since the body cannot continue to rotate about any line which is not a principal axis of maximum moment of Inertia ; that is, the permanent axis turns in a direction at right angles to that in which the torque might be expected to turn it. If the rotating body is symmetrical and its motion unconstrained, and if the torque on the spin axis is at right angles to that axis, the axis of precession will be perpendicular to both the spin axis and torque axis. Under these circumstances the period of precession is given by: : In which ''Is'' is the Moment Of Inertia , ''Ts'' is the period of spin about the spin axis, and ''Q'' is the torque. In general the problem is more complicated than this, however. For a layman’s explanation of Precession: we will have to imagine the wheel of a gyroscope as a group of particles that are being forced to move in circle. Remember the particles want to move in a straight line. In order for the particles to move in a curved line there must be a force. This force is provided by the structure of the wheel holding the particles within the wheel. Now let’s see what happens to our accelerating particles when a torque is applied to the spinning wheel. Assume the axis of rotation created by the torque is through the center of the wheel at 90 degrees to the primary rotation of the wheel. Let’s look at a particle that is on this axis of rotation. Since the particle is on the axis of rotation there is no direct motion applied to the particle at the instant of the applied torque. But let’s look at what will need to happen at the next moment in time. The particle is now going to be forced to curve again. This time in the direction of the curve is to accommodate the tilt of the wheel. Now we have a particle that is already moving and it wants to keep moving in a straight line. So the particle will exert a force on the wheel. If you look at a particle on the other side of the wheel you will see that the force of the second particle is in the opposite direction of the first particle. That pair of unmatched forced is what causes the precession torque that is 90 degrees to the applied torque. Precession of the equinoxes See Also: Precession of the equinoxes The Earth goes through one complete Precession cycle in a period of approximately 25,800 years, during which the positions of Star s as measured in the Equatorial Coordinate System will slowly change; the change is actually due to the change of the coordinates. Over this cycle the Earth's north axial pole moves from where it is now, within 1° of Polaris , in a circle around the Ecliptic Pole , with an angular radius of 23 degrees 27 arcminutes Cook, David R. (1999), "U.S. Department of Energy, Environmental Earth Science Archive, Ask A Scientist" {Link without Title} , or about 23.5 degrees. The shift is 1 degree in 180 years (the angle is taken from the observer, not from the center of the circle). The explanation of this is: The axis of the Earth undergoes precession due to a combination of the Earth's nonspherical shape (it is an Oblate Spheroid , bulging outward at the equator) and the gravitational tidal forces of the Moon and Sun applying torque as they attempt to pull the Equatorial Bulge into the plane of the Ecliptic . The portion of the precession due to the combined action of the Sun and the Moon is called lunisolar precession. Precession of planetary orbits (very exaggerated)]] The revolution of a planet in its Orbit around the Sun is also a form of rotary motion. (In this case, the combined system of Earth and Sun is rotating.) So the axis of a planet's orbital plane will also precess over time. The major axis of each planet's elliptical orbit also precesses within its orbital plane, in response to perturbations in the form of the changing gravitational forces exerted by other planets. This is called perihelion precession. Discrepancies between the observed perihelion precession rate of the planet Mercury and that predicted by Classical Mechanics were prominent among the forms of experimental evidence leading to the acceptance of Einstein 's Theory Of Relativity , which predicted the anomalies accurately. Max Born ( 1924 ), ''Einstein's Theory of Relativity'' (The 1962 Dover edition, page 348 lists a table documenting the observed and calculated values for the precession of the perihelion of Mercury, Venus, and Earth.) It is generally understood that the gravitational pulls of the sun and the moon cause the precession of the equinoxes on Earth which operate on cycles of 23,000 and 19,000 years. The precession of the orbit of the Earth is an important part of the Astronomical Theory of Ice Age s. Precession is also an important consideration in the dynamics of Atom s and Molecule s. See also External links Notes References # "Moon and Spica", StarDate July 14, 2005, University of Texas McDonald Observatory, {Link without Title} |