Float Glass

As the glass flows down the tin bath, the Temperature is gradually reduced until the sheet can be lifted from the tin onto rollers. It then passes through the Lehr where it is further cooled gradually so that it Anneals without strain and does not crack from the change in temperature. The glass tavels down the rollers in the lehr for about 100 metres and comes out at the "cold end" where it is cut by machines.

The nitrogen and hydrogen keeps the tin from Oxidizing . Some tin is absorbed into the glass, and with a proper Ultraviolet Light a sheen can be seen which differentiates the tin from the non-tin side.

In earlier centuries, window glass was made by blowing either large bottles or Large Disks . The bottles were cut apart and flattened and then window panes were cut from the large surface. Most glass for windows up to the early 19th Century was made from rondels, while most window glass during the 19th century was made using the bottle method (these 'bottles' were 6 to 8 feet (2 to 2.5 m) long and 10 to 14 inches (250 to 350 mm) in diameter).

Alastair Pilkington has been identified by many sources as the inventor of the float glass process even though it was first patented in 1848 by Henry Bessemer , an English Engineer . The float glass process was also patented in the United States in 1902 by W. E. Heal and again in 1925 by Hitchcock (a revised version of Heal's patent). Sir Alastair Pilkington was however the first person who successfully developed and achieved a commercial implementation of this revolutionary flat glass production technology.

Before the development of float glass, larger sheets of plate glass were made by casting a large puddle of glass on an Iron surface, and then grinding and polishing both sides to smooth clarity, a very expensive process.

Glass of lower quality, sheet glass, was made by drawing upwards from a pool of molten glass a thin sheet, held at the edges by rollers. As it cooled the rising sheet solidified and could then be cut. The two surfaces were less parallel and of lower quality than those of float glass. This process continued for many years after the development of float glass.

PATENTS

-- ''Manufacture of flat glass''

Information About

Float Glass