| Thermoplastic |
Articles about Thermoplastic |
Website Links For Thermoplastic |
Information AboutThermoplastic |
|
A thermoplastic is a material that is Plastic or deformable, Melt s to a liquid when heated and freezes to a Brittle , Glass y state when cooled sufficiently. Most thermoplastics are high Molecular Weight Polymer s whose Chain s associate through weak Van Der Waals Force s ( Polyethylene ); stronger Dipole-dipole interactions and Hydrogen Bond ing ( Nylon ); or even stacking of Aromatic rings ( Polystyrene ). Thermoplastic polymers differ from Thermosetting polymers ( Bakelite ; Vulcanized Rubber ) which once formed and cured, can never be remelted and remolded. Many thermoplastic materials are Addition Polymer s; e.g., Vinyl chain-growth polymers such as polyethylene and Polypropylene . TEMPERATURE DEPENDENCE Thermoplastics are elastic and flexible above a Glass Transition Temperature ''T''g, specific for each one — the midpoint of a Temperature range in contrast to the sharp Freezing Point of a pure Crystal line substance like Water . Below a second, higher melting temperature, ''T''m, also the midpoint of a range, most thermoplastics have crystalline regions alternating with Amorphous regions in which the chains approximate Random Coil s. The amorphous regions contribute Elasticity and the crystalline regions contribute strength and rigidity, as is also the case for non-thermoplastic Fibrous Protein s such as Silk . (Elasticity does not mean they are particularly stretchy; e.g., nylon Rope and Fishing Line .) Above ''T''m all crystalline structure disappears and the chains become randomly interdispersed. As the temperature increases above ''T''m, Viscosity gradually decreases without any distinct Phase change. Thermoplastics can go through melting/freezing cycles repeatedly and the fact that they can be reshaped upon reheating gives them their name. Animal Horn , made of the Protein α-keratin , softens on heating, is somewhat reshapable, and may be regarded as a natural, quasi-thermoplastic material. Thermoplastics are useful between ''T''g and ''T''m, a temperature range in which most are neither brittle nor liquid. If a plastic with otherwise desirable properties has too high a ''T''g, it can often be lowered by adding a low-molecular-weight Plasticizer to the melt before forming ( Extrusion ; Molding ) and cooling. A similar result can sometimes be achieved by adding non-reactive Side Chain s to the Monomer s before Polymerization . Both methods make the polymer chains stand off a bit from one another. Before the introduction of plasticizers, Plastic Automobile parts often cracked in cold Winter Weather . Another method of lowering ''T''g (or raising ''T''m) is to incorporate the original plastic into a Copolymer , as with Graft Copolymer s of polystyrene, or into a Composite Material . Although modestly vulcanized natural and synthetic rubbers are stretchy, they are Elastomer ic thermosets, not thermoplastics. Each has its own ''T''g, and will crack and shatter when cold enough so that the Crosslinked polymer chains can no longer move relative to one another. But they have no ''T''m and will decompose at high temperatures rather than melt. LIST OF THERMOPLASTICS
SEE ALSO |
|
|