| Combined Heat And Power |
Website Links For Cogeneration |
Information AboutCombined Heat And Power |
| CATEGORIES ABOUT COGENERATION | |
| power stations | |
| electricity | |
| electricity distribution | |
| electric power | |
| sustainable technologies | |
| environment | |
| sustainability | |
|
OVERVIEW Thermal power plants (including those that use Fissile Elements or burn Coal , Petroleum , or Natural Gas ) do not convert all of their available energy into electricity, with the excess being wasted as excess heat. By capturing the excess heat, CHP allows a more total use of energy than conventional generation, potentially reaching an Efficiency of 70-90%, compared with approximately 50% for the best conventional plants. This means that less fuel needs to be consumed to produce the same amount of useful energy. CHP is most efficient when the heat can be used on site or very close to it. Overall efficiency is reduced when the heat must be transported over longer distances. This requires heavily insulated pipes, which are expensive and inefficient; whereas electricity can be transmitted along a comparatively simple wire, and over much longer distances for the same energy loss. Cogeneration plants are commonly found in district heating systems of big towns, universities, hospitals, hotels, prisons, oil refineries, paper mills, wastewater treatment plants, thermal Enhanced Oil Recovery wells and industrial plants with large heating needs. Large or small, most cogeneration projects only produce, more or less, the amount of energy the facility requires. However, thermally Enhanced Oil Recovery (TEOR) plants often produce a substantial amount of excess electricity. After generating electricity, these plants pump leftover steam into heavy oil wells so that the oil will flow more easily, increasing production. TEOR cogeneration plants in Kern County, California produce so much electricity that it cannot all be used locally and is transmitted to Los Angeles . TYPES OF PLANT Topping cycle plants produce electricity first, then the exhaust is used for heating. Bottoming cycle plants, which are rare, produce heat for an industrial process first, then electricity is produced using a waste heat recovery boiler. Bottoming cycle plants are only used when the industrial process requires very high temperatures, such as furnaces for glass and metal manufacturing. Large cogeneration systems provide heating water and power for an industrial site or an entire town. Common CHP plant types are:
Smaller cogeneration units usually use a Reciprocating Engine or Stirling Engine . They use the waste heat in the flue gas and cooling water of gas or diesel engines and replace the traditional gas- or oil-fired boiler (furnace) used in Central Heating systems. Some cogeneration plants are fired by Biomass {Link without Title} . There are also Heat-only Boiler Station s that are dedicated to producing hot water for use in District Heating . MicroCHP engines, Stirling Engines and Fuel Cells . SEE ALSO EXTERNAL LINKS
AND POWER AND HEAT PUMPS]
www.sunmachine.com - A Range of Domestic MicroCHP plants.
|
|
|